Thinking about adding a skylight? The biggest concern is always leaks. Here's why ours don't leak: we build a structural curb between the rafters, wrap it in ice-and-water shield, install step flashing on all four sides, and re-shingle around the unit with proper overlap. Then we verify the seal from inside the attic. Watts Roofing & Maintenance — leak-free skylight installation in Watts.
We install deck-mounted skylights and curb-mounted skylights. Deck-mounted units sit flush against the roof deck and work best for shingle roofs on standard pitch. Curb-mounted units sit on a raised frame and work on flat or low-slope roofs. Both types get the same flashing treatment: ice-and-water shield, step flashing, counter-flashing, and sealant at every transition.
Our Skylight Installation Process
Site Assessment
We assess your roof from above and inside the attic. We locate the trusses and rafters, check the roof deck sheathing condition, and identify the best skylight placement for natural light based on sun angle, room layout, and roof pitch.
Structural Prep
We cut the roof deck opening through the sheathing and shingles, then frame a structural curb between the rafters with doubled lumber. Headers distribute the load around the opening. The curb provides a solid, level base for the skylight unit.
Seal Integration
Full flashing system: ice-and-water shield base layer, step flashing and counter-flashing on all four sides, woven into the existing shingle field. Water flows over the flashing and onto the shingles below — never behind them.
Completion
Unit installed and sealed. Light shaft insulated and trimmed. We verify the seal from inside the attic — if we can see any daylight at the flashing joints, we re-seal before we leave. Your skylight is watertight and energy-efficient.
What Watts Customers Say
"Responded fast and got the job done right the first time. Crew was polite, professional, and cleaned up everything. Would absolutely hire again."
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
"From the first phone call to the final walkthrough, everything was seamless. The team was courteous and efficient. Already recommended them to two friends."
Why Choose Watts Roofing & Maintenance for Skylight Installation?
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.
Brand Options
VELUX, Fakro, Sun-Tek — fixed, vented, and tubular models. Tempered and laminated glass. Built-in blinds and shades. We help you choose the right unit for your roof, room, and budget.
Code Compliant
Every skylight installation meets OK building code for structural framing, energy performance, and egress requirements. Permits pulled when required.
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.